PEAK Products > Electronics
Telligence Technologies
Battery Chargers / Maintainters
PKC0CV - 4/10/20/40 Amp Battery Charger
PKC0CU - 4/12/25 Amp Battery Charger
PKC0CT - 2/8/12 Amp Battery Charger
- High frequency battery chargers charge up to two times faster than comparable standard chargers
- Electronic microprocessor monitors and automatically adjusts voltage and charge rate during multiple states for optimal charge
- Switches automatically from charging to float mode for battery maintenance. Will resume continuous charging when battery becomes discharged.
- Digital LED display for reading amperage, voltage and percentage of battery charged (including “FUL") during charging cycles
- Reverse polarity, short circuit, bad battery and overload protection with indicators and automatic shut down
- Battery charging and battery reconditioning indicators
- Corrosion-resistant, nickel-plated battery clamps connect to side or top-mounted battery terminals
- Durable plastic, water-resistant housing
- Can also charge AGM & deep cycle batteries
PKC0CS - 2/4/6 Amp Battery Charger

- High frequency battery chargers charge up to two times faster than comparable standard chargers
- Electronic microprocessor monitors and automatically adjusts voltage and charge rate during multiple stages for optimal charge
- Switches automatically from charging to float mode for battery maintenance. Will resume continuous charging when battery becomes discharged.
- Charging, reverse polarity, float and battery fully charged indicators
- Corrosion-resistant, nickel-plated battery clamps connect to side or top-mounted battery terminals
- Durable plastic, water-resistant housing
- Can also charge AGM, deep cycle and gel cell batteries
PKC0CA - 2 Amp Battery Charger
- Switches automatically from charging to float mode for battery maintenance. Will resume continuous charging when battery becomes discharged.
- Reverse polarity, charging and float/fully charged indicators
- Corrosion-resistant, nickel-plated battery clamps
- Snap disconnect harness quickly connects battery clamps or rings to top or side battery terminals and 12V DC accessory plug connection to cigarette lighter
- Durable plastic, water-resistant housing
- Can also charge AGM, deep cycle and gel cell batteries
Battery Chargers / Maintainters Spec Sheet
Linear Chargers
PKC0CB - 2/6 Amp Battery Charger
Portable battery charger with both 6 and 12 volt battery charging capability at 6 amp rate

- Built in self-resetting circuit breaker to protect against short circuits
- Includes Heavy duty cables and coppers clamps are corrosion resistant for better connections
- Connects to side or top-mount battery terminals
- Rugged steel case and sturdy handle
PKC0CG - 2/10/55 Amp Battery Charger
Portable battery charger which has 55 amps and 12V vehicle jumpstart capability

- Automatically taper charges and stops charging when the battery is fully charged
- Heavy duty transformer and rectifier for dependability
- Built in circuit protection guards against short circuit
- Automatically checks for correct polarity (requires a minimum of 1.5 volts DC at the battery terminals)
- Heavy duty cables and steel nickel plated clamps are corrosion resistant for better connections
- Connect to side or top mount battery terminals
- Rugged steel case plus sturdy handle
PKC0AL - 2/10 Amp 12V Marine and Automotive Battery Charger
Charges Marine and Automotive 12 Volt batteries at both 2 and 10 amp rates

- Automatic float operation: shuts off upon full charge, resumes charging after battery has discharged.
- Built in self-resetting circuit breaker to protect against short circuits
- Heavy duty cables and clamps are corrosion resistant
- Automatically check for correct polarity
- Power on charging and fully charged LED indicators
- Connect to side or top mounted battery terminals.
PKC0CD - 2/12/70 Amp Battery Charger / Engine Starter
Portable battery charger with 70 amps and 12V vehicle jump-start capability

- Manually charges 6 volt battery at up to 12 Amps
- Automatically taper charges and stops charging when the battery is fully charged
- Heavy-duty transformer and rectifier for dependability
- Built-in circuit protection guards against short circuit
- Automatically checks for correct polarity (requires a minimum of 4 volts DC at the battery terminals)
- Heavy-duty cables and steel nickel plated clamps are corrosion resistant for better connections
- Connect to side or top mount battery terminals
- Rugged steel case plus sturdy handle
- Ideal for charging or boosting during winter season
PKC0BW - 2/15/100 Amp Battery Charger / Engine Starter
Portable battery charger with 70 amps and 12V vehicle jump-start capability

- Manually charges 6 volt battery at up to 15 Amps
- Automatically taper charges and stops charging when the battery is fully charged
- Heavy-duty transformer and rectifier for dependability
- Built-in circuit protection guards against short circuit
- Automatically checks for correct polarity (requires a minimum of 4 volts DC at the battery terminals)
- Heavy-duty cables and steel nickel plated clamps are corrosion resistant for better connections
- Connect to side or top mount battery terminals
- Rugged steel case plus sturdy handle
- Ideal for charging or boosting during winter season









